David Clark 9800 Series Instrukcja Instalacji Pobierz pdf (Strona 20)

9532P-62 (03-11)

of 32

Procedure

• S

pecial note for C98-50LN: See Appendix A for connector assembly instructions .

• For In-Line installation:

q Determine the location for the System Cable/Fitting. Maximum panel thickness is 7/32”.

q Drill 27/32” hole in panel where System Cable is to be installed.

q Remove mounting nut from cable fitting and put in a safe place.

q Snake cable through hole from the outside (headset side) in.

q Slide mounting nut back onto cable and snugly tighten the cable fitting, leaving 3-4 inches

of length between cable fitting and headset end of cable

q Route the cable between each Headset/Station and the Master Station. The cable

should be routed using under-deck conduits and be as far as possible from radio antenna

coax cables and anywhere water may collect. Coil and tie-wrap any excess cable.

q Determine which position this Headset/Station is (Captain/Co-Captain/Passenger) and

connect System Cable to the Master Station. See Figures 1&4 for connector locations.

q To connect cable to master station, align keyways and push. Then firmly turn collar

clockwise until it locks into place. Pull back gently on the cable to ensure connector is

properly locked.

q Repeat this procedure for each C98-XXLN cable to be installed.

• For Panel-Mount installation:

q Determine location for the panel to be mounted.

q Use the template in Figure 11 to mark and drill the five holes in the surface. Use a 7/8”

bit for the center hole and a 5/32” bit for the four corners.

q Route the cable through the 7/8” center hole all the way to the Master Station. The cable

should be routed using under-deck conduits and be as far as possible from radio antenna

coax cables and anywhere water may collect. Coil and tie-wrap any excess cable.

q Secure Panel to surface using the screws, washers, and nuts provided. See Figure 10.

q Determine which position this Headset/Station is (Captain/Co-Captain/Passenger) and

connect System Cable to the Master Station. See Figures 1&4 for connector locations.

q To connect the cable to the Master Station, align keyways and push. Then firmly turn

collar clockwise until it locks into place. Pull back gently on the cable to ensure

connector is properly locked.

q Repeat this procedure for each C98-XXPN cable to be installed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 42 43

Brak uwag

David Clark 9800 Series Instrukcja Instalacji Strona 20